An indwelling catheter is a flexible tube that’s put into your bladder to drain urine. It’s held in place by a small, water-filled balloon inside your bladder. The catheter (often called a Foley) is connected to a tube that leads to a drainage bag. Urine from the catheter drains through the tube into the drainage bag.
What types of drainage bags are there?
There are 2 types of drainage bags:
- a smaller bag (also called a day bag or leg bag) that straps around your thigh and is worn under your clothes during the day
- a larger bag (also called a night bag) that attaches to your bed or wheelchair
If you use a smaller bag during the day, you’ll need to connect the catheter or the smaller drainage bag to a larger drainage bag at night.
How do I care for my catheter?
Always wash your hands with soap and water or an alcohol-based cleaner before and after doing catheter care. Use soap and water if your hands look dirty, not an alcohol-based cleaner. If you need help, it’s important that you ask someone who knows how to do catheter care.
Before you clean your catheter:
- Attach the catheter to your body to prevent tugging or pulling it out. Be careful not to pull on the catheter.
Women: Attach the catheter loosely to your upper thigh with a catheter holder, using a leg strap or tape (see Figure 1).
Men: Attach the catheter to your upper thigh or tummy. (You can visit a health supply store to choose a device to hold the catheter in place).
- Make sure the catheter is connected to a drainage bag and tubing (see Figure 2).
- Check the tubing for kinks, bends, or twisted areas (see Figure 3).
- Straighten out the tubing if it is kinked, bent, or twisted.
- Always keep the drainage bag below the level of the bladder so the urine drains out of the bladder and into the drainage bag.
- Don’t put the drainage bag on the floor.
To clean your catheter:
- Gently wash the catheter (where it leaves the body) and your genital area with soap and water. It’s best to do this in the shower, if you can. Rinse the catheter and genital area well with clean water and gently dry. Wash your catheter and genital area each day.
- Don’t put powder or lotion on the catheter or the area where it goes into your body.
When do I change the drainage bag?
Change to a new drainage bag:
- when it’s time to change the catheter
- if it has a smell, changes colour, or can’t be cleaned
- if it leaks or has a hole or tear
- if you are switching from a smaller bag (leg bag) to a larger bag (night bag) daily, change to a new bag every 7 days
- if the anti-reflux valve (see Figure 2) lets water or urine back up in the tubing
You can check that the valve is working by turning the bag upside down and making sure that urine doesn’t flow back into the tubing. Keep the cap on your drainage bags between changes.
When do I empty the drainage bag?
Don’t let your drainage bag get too full. Empty the drainage bag:
- when it’s 1/2 to 2/3 full
- at least every 4 to 8 hours
- if you switch from one type of drainage bag to another
You may need to empty the smaller drainage bag more often, if you use one during the day.
How do I empty the drainage bag?
Always wash your hands with soap and water or an alcohol-based cleaner before and after you empty the drainage bag.
If you need to measure and record the amount of urine in the bag:
- Take off the stopper or clamp and drain the urine into a clean measuring cup with measure markings.
- Write down the amount of urine measured, the colour and smell of the urine (should be clear yellow with a mild smell), and the date and time.
Pale, clear, yellow, mild smell
- Don’t touch the drainage spout with your fingers and make sure it doesn’t touch the toilet, measuring cup, or floor.
- After you empty the bag, wipe the drainage spout and cap with a 70% alcohol swab and put the stopper or clamp on.
- Wash the measuring cup.
If you don’t need to measure your urine, drain it into the toilet after you take off the stopper or clamp. Also follow the rest of the instructions above.
How do I change my drainage bag?
Always wash your hands with soap and water or use an alcohol-based cleaner before you remove or attach the tubing and drainage bag to your catheter.
To remove the tubing and drainage bag from your catheter:
- Empty the drainage bag (see the instructions above).
- Wipe the connection between the catheter and drainage tube with a 70% alcohol swab.
- Pinch or squeeze the catheter tubing closed with a clamp.
- Remove the drainage tubing from the catheter. Don’t touch the open end of the tubing or catheter when you disconnect them.
- Take the cap off the clean drainage tubing and bag.
- Attach the clean tubing and bag to the catheter. Keep the tubing straight so it drains downwards.
- Unclamp the catheter.
- Save the cap from new drainage bag. Once you’ve cleaned the drainage bag you just removed, put the cap on the clean, disconnected end of the tubing.
Only remove the drainage bag from the catheter when you need to. Instead of removing a smaller bag from your catheter, you can attach a larger drainage bag to the drainage spout of the smaller bag so there’s more space for urine to drain during the night.
If you switch from a smaller drainage bag to a larger bag at night, only remove the catheter from the tubing and bag when you change bags.
How do I clean the drainage bags?
Clean and disinfect the sink and counter or other area where you will clean your bag. Always wash your hands with soap and water or an alcohol-based cleaner before you clean your bag.
Get the following before you begin cleaning your bag:
- clear liquid soap (regular dish soap is fine)
- a clean measuring cup
- 1:1 water and vinegar solution – Mix together 1 part white vinegar and 1 part water (for example, 1 cup of vinegar and 1 cup of water).
- a clean, 60 mL slip-tip syringe or a squeeze bottle
- a clean towel or paper towels
- clean gloves (if you want to use them)
- 70% alcohol or chlorhexidine swabs
To clean the bag:
- Put on gloves (if you want to wear them).
- Empty the drainage bag and disconnect the tube (see instructions above).
- Connect another drainage bag to the catheter.
- Put a few drops of liquid soap and 1 cup of water in the squeeze bottle.
- Squeeze the soapy water into the drainage bag.
- Gently shake the soapy water around in the drainage bag to loosen anything that might be stuck inside. Rub and shake the sides of the bag. Make sure the whole bag is clean, including the drainage spout and tubing.
- Pour the soapy water out through the drainage spout and tubing.
- Flush the drainage bag with tap water, until the water runs clear. Make sure there is no soap left in the bag, spout, and tubing.
- Rinse the soapy water from the squeeze bottle.
- Put the vinegar and water solution in a syringe or squeeze bottle and squeeze it into the drainage bag to rinse it out. Shake the bag and let the vinegar and water sit for 15 minutes. Then rinse the bag out with cool tap water.
- Let the drainage bag, spout, and tubing air dry on a clean, dry surface. Make sure the spout, connector, and tubing don’t touch anything.
- Wipe all ends with alcohol or chlorhexidine swabs before you reconnect them.
- Empty and wash the squeeze bottle or syringe with hot, soapy water, then rinse it, and let it air dry. Wash it after each time you use it.
- Take off the gloves (if you wore them) and wash your hands.
Other things to know
Throw out the syringe or squeeze bottle if it:
- looks damaged or broken
- changes colour
- starts to feel different (for example, harder or softer)
If you switch to a smaller bag during the day, clean the larger bag after you remove it.
If the leg strap for the smaller bag gets dirty, wash it with soap and water and let it air dry.
What should I do if the drainage bag isn’t collecting any or much urine?
If there isn’t any or much urine in the drainage bag:
- Check the tubing to see if it’s twisted, bent, or plugged.
- Check the catheter where it goes into your body to see if it’s kinked or twisted.
- Make sure you aren’t lying on the tubing and that the bag is lower than your bladder.
- Change positions.
If you still don’t see any urine collecting in the drainage bag, call your healthcare provider.
When should I call for help?
Call your healthcare provider if you have any of the following:
- a temperature of 38 °C or chills
- pain in your back, stomach, or sides
- you feel sick to your stomach or you’re throwing up
- the area where the catheter goes into your body is sore, red, swollen, or you see blood
- your urine changes colour (to red or brown), is cloudy, thick, or smells bad
- unusual itching, swelling, or new pain in your bladder or urethra that doesn’t go away
- the catheter comes out or leaks urine
- your bladder feels full
- you think your catheter is blocked or plugged (if you’re drinking enough fluid but don’t see any or much urine in the drainage bag)
What else do I need to know?
If you have home care or other type of nursing care in your home, ask your case manager if you need any catheter supplies at home in case your catheter needs to be changed.
Drink enough fluids to prevent constipation (when you have hard stool and trouble passing it). Constipation can cause the catheter to leak.
Drinking enough fluids can also help prevent the catheter from getting plugged. If you’re drinking enough fluids, your urine should be pale yellow.
If you notice anything unusual with your catheter, make a note and let your healthcare provider know.
If you have questions about intimacy and sex, talk to your healthcare team. Your doctor and healthcare team is there to support you.
- Evidence-Based Guidelines for Best Practice in Urological Health Care: Urethral and Suprapubic, European Association of Urology Nurses, 2012.
To see this information online and learn more, visit MyHealth.Alberta.ca/health/pages/conditions.aspx?Hwid=custom.ab_indwellingcatheter_inst.
For 24/7 nurse advice and general health information call Health Link at 811.
Current as of: September 25, 2020
Author: Home Care, Alberta Health Services
This material is not a substitute for the advice of a qualified health professional. This material is intended for general information only and is provided on an "as is", "where is" basis. Although reasonable efforts were made to confirm the accuracy of the information, Alberta Health Services does not make any representation or warranty, express, implied or statutory, as to the accuracy, reliability, completeness, applicability or fitness for a particular purpose of such information. Alberta Health Services expressly disclaims all liability for the use of these materials, and for any claims, actions, demands or suits arising from such use.